Andy, 

They are not tipped prior to installation.  You may request anywhere up to 1.5" tipping on those shafts.

Cameron

1-888-TITLEIST  

How much should the diamana D+ be tipped in order to get the stiffness right between stiff and extra stiff?

Why do you want to change the kick point, torque, launch angle,and swing weight of your club?

The proper way to shorten a club is to take an equal amount of trim from the butt and tip

But if you realy want to get between stiff and extra stiff take a 1/2" off the butt end

We can tip the shaft as much a 1.5", but to get it in between flexes, you would want to have it tipped 1". 

So to confirm the shafts are not tipped for 913, but the 910 shafts were tipped 1/2". Can anyone expound on why the shafts are no longer tipped to play to flex when the surfit adaptor hasn't changed?  I'm confused?

After studying the tip trim chart of various shafts of all the various manufacturers it seems every shaft is different...it appears according to Mitsubishi they do not recommend trip trimming for the driver however if you are looking to adjust between flexes you would need to give Titleist that custom information. 

The tipping is exactly the same for the 913's as it was for the 910's.  We are not tipping the Diamana plus series, but do tip all other shafts 1/2" for the driver.  We can tip per request.

Why 1/2 " ? How do you get this number?  Why not 1/3"?

This was just a number that was determined by the recommendations from the company and the results from testing with out R&D Teams to find the best performance.

Cameron

1-888-TITLEIST

Hey Cameron!  

Can you tell me what the stock tip trim on the 915 D3 driver would be with an aldila rogue black shaft?  Does the tip trim change with the flex and/or the weight?  

The Rogue Black shafts are tipped 1/2" unless requested otherwise.  It does not matter what weight or flex for that shaft - same tipping.

Can you advise on what the untipped shaft measurement should be from the Surefit Adapter tip to the N on the Mitsubishi Rayon logo (for OEM Diamanas and Fubuki K) for both driver and fairway (3) woods?

Also how would you measure on Fujikura shafts - specifically the VC series?

Thanks in advance!

Kevin H

Kevin, 

Are you looking to ultimately find out the finished length of these shafts?

Cameron

1-888-TITLEIST