AP1 716 raw shaft length and tip diameter?

Follow Thread

By Jason P

  • 0 Likes
  • 2 Replies
  1. Jason P

    Jason P

    I want to combo a 4-7i AP1 716 with my 8-W AP2 714's with kbs tour v x shafts.

    I currently have kbs tour v x's in the 8-pw in my 714's and need to buy a 4, 5, 6, 7, & W kbs tour v x shafts for the AP1 716's.

    Two questions:

    1) Will a KBS Tour V .355 work (fit) in the AP1 716's?

    if so,

    2) which raw lengths should I purchase for the 4-7i and the W? (I'm not looking to hard or soft step).

    Many thanks, Jason

  2. Chris T., Club Concierge

    Chris T., Club Concierge
    Carlsbad

    Hi Jason,

    All of our irons and wedges use .355 taper tip shafts, so you are correct on the diameter.

    For standard builds we use a shaft that is one inch longer than the stock build length, so you will need lengths of 39.5", 39", 38.5", 38", and 36.5" for the gap wedge.

    Please keep in mind there will be a large loft gap of seven degrees between your AP1 7 iron and AP2 8 iron at standard specification. We would not recommend bending loft more than 2 degrees in either direction, but you will want to address this during the build process.

    Hope this helps
  3. Lee S

    Lee S

    Military
    The 716 AP1 irons will bend to 4 degrees up, a little at a time, which is where I have mine.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up

Find a golf store near me