43.5 inch 910 D3 DRIVER

Unfollow Thread

By Bob M

  • 0 Likes
  • 3 Replies
  1. I have a fitting scheduled for the 910 D3 driver and would like to order with a 43.5 inch shaft after my fitting, will the swing weight and club characteristics be adjusted for the shorter shaft from the factory? Should i be aware of anything when geting fitted with a longer shaft, that might be effected.

  2. Joe B

    Joe B
    Philadelphia, PA

    What is your reasoning for getting the 43.5" length? I would see how the fitting goes. Most likely the fitter won't have a shaft that short for you to test. I would recommend ordering at 44" and adjusting further if needed. Swingweight screws are easy. Just my opinion. Good luck, Joe Burdess Titleist Regional Fitter
  3. Joe, currently choke down on my 45 inch driver about 1.5 inches trying to hit the sweet spot and more fairways.I currently have a demo which is 45 inch and set on B1, working well but swing weight feels different when choking down. Just wondering how i can dial this whole thing, will be seeing a fitter tomorrow afternoon. More fairways and therefore more greens.

  4. Cath D.

    Cath D.
    Carlsbad, CA

    Bob M said:

    I have a fitting scheduled for the 910 D3 driver and would like to order with a 43.5 inch shaft after my fitting, will the swing weight and club characteristics be adjusted for the shorter shaft from the factory? Should i be aware of anything when geting fitted with a longer shaft, that might be effected.

    We will build it as short as 44". You can have it built with the grip in the box if you feel you need it at 43.5". As far as swingweight goes, at 44", it will depend on the weight and balance point of the shaft. For example, if you used an Ahina 72 S/X flex, we could probably get to D1-D2 at 44" with a 12 gram weight. Getting a ligher grip will help somewhat, but it will reduce the overall weight.

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up